This on-demand LP Gas hot water heater will allow you to have instant hot water anytime and replaces the old style passive heat systems. Never run out of hot water again. Health inspectors love them and you can install one in about an hour to an existing system. Requires a pressurized water system. Note: if you have the old style gravity flow water system, you will need to purchase a pump.

  • Constant Temperatures
  • No electrical hookups needed
  • Up to 1.5 gallons per minute
  • No pilot light
  • Ignites on demand when you turn on faucet • Adjustable water temperature [IMPORTANT NOTE: all on demand heaters will retain a small amount of water inside the internal components – to avoid damage, either add food safe anti-freeze to lines or protect heater from below freezing temps]

SPECS / OPTIONS

  1. Constant Temperature
  2. No electricity needed LP GAS 3.37,500 BTU output rating
  3. 18 3/4″ tall, 12 1/2″ wide and 5″ deep
  4. Up to 1.5 gallons of hot water per minute
  5. Installed to the on board pump.
  6. Adjustable water temperature from 80-150 degrees F
  7. On / off switch for running water without heat
  8. Operates with 20-80 PSI of water pressure
  9. Minimum flow rate is approximately 1.3 liters per minute
  10. 20 minute auto safety shut off timer
  11. One year Manufacturer's Warranty
  12. Weighs just 12 lbs with gas hose and regulator
  13. No pilot. Ignition system powered by 2 D cell batteries (not included)

*** [IMPORTANT NOTE: all on demand heaters will retain a small amount of water inside the internal components – to avoid damage, either add food safe anti-freeze to lines or protect heater from below freezing temps]***